Sony PEGA-CC5 Operating Instructions Manual page 79

GPS
GPS signal cannot be received.
• The system cannot receive GPS signals due to an obstruction.
tMove your car somewhere clear.
• GPS signal reception is low.
tActivate the GPS Meter application and check the GPS signal values.
• The GPS aerial is incorrectly installed.
tInstall the GPS aerial where the signal is not interrupted by the body of the car,
and install the aerial horizontally on the roof.
For details, refer to the Installation/Connections manual.
• The GPS aerial is not properly connected to the car cradle.
tInsert the connector of the aerial cable until it clicks into the GPS ANT port of the
car cradle.
For details, refer to the Installation/Connections manual.
The map of my current GPS location does not match the current road when
using the SmartST™ Professional application.
The error margin of the signal from the GPS satellites is too large. An error margin of
a few hundred meters can exist in the worst case.
Function
The built-in speaker does not work for the Text-to-voice function.
Is the volume too low? Is the ATT on?
The volume adjustment and ATT button do not work.
You can adjust the volume level only while the Text-to-voice application is being used
or read out.
The LINE-OUT output does not function.
When the SONY-BUS connection adapter is connected between Sony car audio and
the car cradle, the LINE-OUT output does not function.
Music is not playing through the built-in speaker.
The built-in speaker is only for Text-to-voice applications, not for music.
The wireless card remote commander does not function.
When the battery becomes weak, the range of the wireless card remote commander
becomes shorter (page 76). Buttons may not function depending on the operating
situation.
The dimmer does not function.
tMake sure the dimmer position is AUTO (page 12).
Continued on next page
• • • • • • • • • • • • • • • • • • • • •
79