Using 3D Reform; Selecting Gamma Correction Mode; Selecting Color Correction; Adjusting Color Temperature And White Balance - NEC MT1075/MT1065 User Manual

Selecting Gamma Correction Mode

Use the or buttons to choose one mode from three options.
Each mode is recommended for :
Dynamic ......... For true color reproduction of natural tones
Natural ........... Normal settings
Black Detail .... For dark portions of a picture

Selecting Color Correction

Adjusts red, green, blue, yellow, magenta, cyan and color gain each
independently to correct the tint on whole screen.

Adjusting Color Temperature and White Balance

This feature adjusts the color temperature using the slide bar.
Checking "Color Temperature" enables the color temperature slide
bar and disables the "White Balance" button.
Clear "Color Temperature" and press the White Balance button to
access the Contrast/Brightness adjustment for each R, G, and B.
NOTE: "Color Temperature" and "White Balance" are a trade-off.
The White Balance is not available for Viewer and LAN.

Selecting Base Setting

This feature allows you to use color correction or gamma values as
reference data to optimize for various types of images. You can select
one of the following five settings.
• Presentation • sRGB
• Video • Movie
• Graphic

Projector Options

Using 3D Reform

This feature corrects trapezoidal distortion so that the projected im-
age is rectangular.
Two options are available for correcting procedures.
You can save adjustment settings by using the 3D Reform Save op-
tion on Setup (See page E-47).

Cornerstone

See page E-20.

Keystone

1. Press the SELECT
2. Press the SELECT
3. Press the SELECT
4. After completing, press the ENTER button. This will return to the menu
screen.
* When "Resolution" is set to "Native", "Cornerstone" and "Keystone"
are not available.
Keystone Correction at Zoomed Lens Position
You can zoom in or out, while keeping an image that was corrected
using Keystone, without again having to make those adjustments.
Improvements in 3D Reform performance allows the projector's adjust-
ment range (horizontal and vertical combinations) to be wider by ap-
proximately 25% in the maximum telephoto position when compared to
initial units shipped.
NOTE: There are some cases when adjusting the zoom position from Tele to
Wide (after performing Keystone correction in Tele) can result in a message
"Range Over ! 3D Reform data has been cleared.". In this case correction values
for Keystone will return to the factory default setting.
E-42
button to adjust the horizontal keystone.
button to select "Vertical".
button to adjust the vertical keystone.