Options; Location Requirements - Whirlpool 3LCHW9100WQ Installation Instructions Manual

Semi-pro front-load washer
Hide thumbs Also See for 3LCHW9100WQ:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Options

Pedestal
You have the option of purchasing pedestals separately for this
washer. The pedestal will add to the total height of the washer.
Optional pedestal
Pedestal
Approximate
Color
Part Number
Height
height
with washer
(73 mm) 2
7
/
"
(1207 mm) 47.5"
White
WHP0400VW
8

Location Requirements

Selecting the proper location for your washer improves
performance and minimizes noise and possible washer “walk.”
Your washer can be installed under a custom counter, or in a
basement, laundry room, or recessed area. See “Drain System.”
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
A water heater set to deliver 60°C (140°F) water to the
washer.
An earthed electrical outlet located within 1.8 m (6 ft.) of
where the power cord is attached to the back of the washer.
See “Electrical Requirements.”
Hot and cold water taps located within 1.2 m (4 ft.)
of the hot and cold water fill valves, and water pressure
of 137.9-689.6 kPa (20-100 psi).
A level floor with a maximum slope of 25 mm (1") under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
A sturdy and solid floor to support the washer with a total
weight (water and load) of 180 kg (400 lbs).
Do not operate your washer in temperatures below 0°C (32°F).
Some water can remain in the washer and can cause damage
in low temperatures.
Installation clearances
The location must be large enough to allow the washer door
to be fully opened.
Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90°
and it is not reversible.
Additional clearances might be required for wall, door, and
floor moldings.
Additional spacing of 25 mm (1") on all sides of the washer
is recommended to reduce noise transfer.
Companion appliance spacing should also be considered.
Removal of mains plug provides the function of an
emergency stop control. When installed, the mains plug
must be visible and accessible to the user for washer
disconnection from the mains supply.
Washer Dimensions
686 mm
1282 mm
(27")
1
(50
/
")
2
961 mm
5
(37
/
")
6
732 mm
13
(28
/
")
16
Door is not reversible.
A floor drain should be provided under the bulkhead.
Prefabricated bulkheads with electrical outlets, water
inlet lines, and drain facilities should be used only where
local codes permit.
Page 5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents