Download Print this page

Charging Procedure; Important Charging Notes - Black & Decker SZ360 Instruction Manual

Hide thumbs

Advertisement

635381-00 01 SZ360 Scissors
6/9/06
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
240V
0-50
51-100 101-200 201-300
Ampere Rating
More Not more
American Wire Gage
Than Than
0
-
6
18
6
-
10
18
10
-
12
16
12
-
16
14
8. Use only the supplied charger when charging your tool. The use
of any other charger could damage the tool or create a
hazardous condition.
9. Use only one charger when charging.
10. Do not attempt to open the charger. There are no customer
serviceable parts inside. Return to any authorized Black &
Decker service center.
11. DO NOT incinerate the tool or batteries even if they are severely
damaged or completely worn out. The batteries can explode in a
fire.
12. A small leakage of liquid from the battery cells may occur under
extreme usage, charging or temperature conditions. This does
not indicate a failure. However, if the outer seal is broken and
this leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If the battery liquid gets in your eyes, flush them with clean water
for a minimum of 10 minutes and seek immediate medical
attention. MEDICAL NOTE: The liquid is a 25-35% solution of
potassium hydroxide.

Charging Procedure

THE BATTERIES IN YOUR SCISSORS ARE NOT FULLY
CHARGED AT THE FACTORY. BEFORE ATTEMPTING TO
1:39 PM
Page 4
51-100 101-150
16
16
14
16
14
12
16
14
12
12
Not Recommended
CHARGE THEM, THOROUGHLY READ ALL OF THE SAFETY
INSTRUCTIONS.
To charge the batteries, follow the steps below.
1. Make sure tool is in the "OFF" position before charging.
2. Plug the output cord of the charger into the
socket in the bottom half of the scissors
handle as shown in figure 1.
3. Plug the charger into any standard 120
Volt 60 Hz electrical outlet.
4. Let the tool charge for 12 hours. After the
initial charge, under normal usage, your
tool should be fully charged in 12 hours.
WARNING: When disconnecting from the
charger, be sure to unplug the charger from the outlet first then
disconnect the charger cord from the scissors. Do not use the
scissors while it is connected to the charger. When plugged in unit
becomes inoperable.

Important Charging Notes

1. After normal usage, the scissors should be fully charged in 12
hours. Your tool was sent from the factory in an uncharged
condition. Before attempting to use it, it must be charged for at
least 12 hours.
2. DO NOT charge the batteries in an air temperature below 40°F
(4,5 °C) or above 105°F (+40,5 °C). This is important and will
prevent serious damage to the batteries. Longest life and best
performance can be obtained if batteries are charged when air
temperature is about 75°F.
3. While charging, the charger may hum and become warm to
touch. This is a normal condition and does not indicate a
problem.
4. If the batteries do not charge properly—(1) Check current at
receptacle by plugging in a lamp or other appliance. (2) Check to
see if receptacle is connected to a light switch which turns power
off when you turn out the lights. (3) Move charger and tool to a
surrounding air temperature of 40°F (4,5 °C) or above 105°F
(+40,5 °C). (4) If the receptacle and temperature are OK, and
4
1

Hide quick links:

Advertisement

loading

  Also See for Black & Decker SZ360