Check The Print Quality; Set The Date And Time - Brother DCP-J4110DW Quick Setup Manual

e
Take care to match the sticker colour with the
cartridge colour.
Install each ink cartridge in the direction of the
arrow on the label.
f
Gently push the back of the ink cartridge
marked "PUSH" until the cartridge lever lifts.
After all the ink cartridges are installed close
the ink cartridge cover.
NOTE
The machine will prepare the ink tube system for
printing. This process will take approximately four
minutes. Do not turn off the machine.
6

Check the print quality

a
When the preparation process has finished, the
Touchscreen shows Set Paper and Press
Start.
Press Start.
b
Check the quality of the four colour blocks on
the sheet. (black/yellow/cyan/magenta)
c
If all lines are clear and visible, press Yes to
finish the quality check and go to the next step.
If you can see missing short lines, press No and
follow the steps on the Touchscreen.
7
Choose your language
(if needed)
a
Press Settings.
b
Press s or t to display Initial Setup.
Press Initial Setup.
c
Press s or t to display Local Language.
Press Local Language.
d
Press your language.
e
Press .
8

Set the date and time

a
Press Settings.
b
Press s or t to display Initial Setup.
Press Initial Setup.
c
Press Date & Time.
d
Press Date & Time.
Enter the last two digits of the year on the
Touchscreen, and then press OK.
To move the cursor to the left, press
re-enter the number.
e
Repeat for month/day/time in 24-hour format.
f
Press .
and
5