Indication Lamp - Makita BUK360 Instruction Manual

012933
Fit the holder (optional accessory) in the hole on the left
side of the handle from the operator's view. And then
push the cord into the holder so that the cord tension is
not too loose. Make sure the cord is secured with the
cord holder.
1 3
012936
Open out the battery hood and then slide all the way and
click the product mounting adapter of the BCV01 into the
battery port 1.
012935
Pull up lightly and remove the rubber cap from the slit in
the lower housing as shown in the figure.
NOTE:
Do not pull up the rubber cap forcibly because
•
forcing it may damage its retaining section.
1
2
012931
1. Holder
1
1. Battery port 1
2. Battery port 2
2
3. Rubber cap
2
1
1. Rubber cap
1
1. Battery hood
2. Product
mounting
4
adapter of the
BCV01
3. Cord
4. Slit in the lower
housing
3
Bend the cord of the battery converter BCV01 over the
product attachment section. Then run the cord of the
BCV01 through the slit in the lower housing and close the
battery hood.
To remove the BCV01, follow the installation procedure
in reverse.
BCV03 (optional accessory)
014474
Open the battery hood and click in the BCV03 into the
battery port. Close the battery hood.
To remove the BCV03, press on the hook of the BCV03
and withdraw it with both hands.

Indication lamp

WARNING:
Do not use the battery selection switch during the
•
operation.
After flipping the battery selection switch, the main
•
switch is turned off. To start the tool, the operator
needs to press the main switch.
4
1. Indication lamps
2. Battery lamp 1
3. Battery lamp 2
4. Warning lamp
5. Battery selection switch
012839
7
1. Battery
converter
(BCV03)
1
2
3
1
5