Table of Contents
Advertisement
M2266S1H
Technical Handbook
Section 3. Hardware Installation
This section describes how to handle the drives, make connections, set
switches and plugs, mount drives, connect cables, confirm drive operations
after installation, prepare the drives for use, and remove the drives.
Notes on Handling Drives
General Notes
• To avoid damage to the drive, do not allow vibration or shocks
exceeding the values defined in the standard. Be especially careful
during unpacking.
• Do not leave the drive in a dirty or contaminated environment.
• Since static discharge may destroy the CMOS semiconductors in the
drive, use an antistatic mat after unpacking, and ground yourself when
handling the drive.
• Hold the DE. or mounting frame when handling the drive. Do not touch
PCAs, except when setting switches.
Unpacking
• Use a flat work area. Be sure that the "This Side Up" sign is up. Handle
the drive of soft material such as a rubber mat, not on hard material such
as a desk. Handle the drive gently at all times.
• Do not remove the sealing label or cover of the DE and screws.
Installation
• While power is turned on, do not connect or disconnect connectors or
change terminals except CN3 and CN9.
• Do not move the drive when power is turned on or until the drive has
been completely stopped for 15 seconds after the power is turned off.
Fujitsu America, Inc.
FS810125-01 . . . A
3-1
Advertisement
Table of Contents
