Download Print this page

Troubleshooting - Black & Decker BDCS30 Instruction Manual

Hide thumbs

Advertisement

repair, or genuine factory replacement parts,
contact the BLACK+DECKER location nearest
you. To find your local service location, call:
1-800-544-6986 or visit
www.blackanddecker.com
This Class B digital apparatus complies
with Canadian ICES-003. This device
complies with part 15 of the FCC rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
Problem
• Tool will not charge.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DECKER help line at
1-800-544-6986.

Troubleshooting

Possible Cause
• Charger not plugged into
a working outlet.
• Surrounding air temperature
too hot or too cold.
8
radio/TV technician for help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
This Class B digital apparatus complies
with Canadian ICES-003.
TWO-YEAR LIMITED WARRANTY
Black & Decker (U.S.) Inc. warranties this
product to be free from defects in material
or workmanship for a period of two (2) years
following the date of purchase, provided that
the product is used in a home environment.
This limited warranty does not cover failures
due to abuse, accidental damage or when
repairs have been made or attempted by
anyone other than BLACK+DECKER and
its Authorized Service Centers. A defective
product meeting the warranty conditions set
forth herein will be replaced or repaired at
no charge in either of two ways:
The first, which will result in exchanges
only, is to return the product to the retailer
from whom it was purchased (provided
that the store is a participating retailer).
Returns should be made within the
time period of the retailer's policy for
exchanges. Proof of purchase may be
required. Please check with the retailer
for its specific return policy regarding
time limits for returns or exchanges. The
second option is to take or send the product
(prepaid) to a BLACK+DECKER owned
or authorized Service Center for repair
or replacement at BLACK+DECKER 's
option. Proof of purchase may be required.
BLACK+DECKER owned and authorized
service centers are listed online at www.
blackanddecker.com.
This warranty does not apply to accessories.
This warranty gives you specific legal rights and
Possible Solution
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Check current at
receptacle by plugging in
a lamp or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when you turn
out the lights.
• Move charger and tool
to a surrounding air
temperature of above 40
degree F (4,5°C) or below
105 degree F (40,5°C).

Hide quick links:

Advertisement

loading