Programming The Remote Control - Sony TRINITRON KV-27HS420 Service Manual

Programming the Remote Control

Notes
If you have video equipment other than Sony brand (or if you have a
Sony DVD/VCR combination unit) that you want to control with the
TV's remote control, use the following procedure to program the
remote control.
✍
The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
1
Turn to the list of "Manufacturer's Codes" on page 38, and find
the three-digit code number for the manufacturer of your
equipment. (If more than one code number is listed, use the
number listed first.)
2
Press
CODE SET.
3
Press the
VCR/DVD FUNCTION
4
Using the - buttons, enter the three-digit manufacturer's code
0 9
number.
5
Press the button.
ENTER
✍
You must do step 5 within 10 seconds of step 4, or you must redo
steps 2 through 5.
6
To check if the code number works, aim the TV's remote control
at the equipment and press the
with that equipment. If it responds, you are done. If not, try using
another code listed for that manufacturer.
❑
If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
❑
If you enter a new code number, the code number you previously
entered at that setting is erased.
❑
In some cases, you may not be able to operate your equipment
with the supplied remote control. In such cases, use the
equipment's own remote control.
❑
Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be
reprogrammed.
or button.
SAT/CABLE FUNCTION
button that corresponds
POWER
37