Ventilation Requirements For Enclosure Mounting - NEC LCD4000 User Manual

You can attach mounting accessories to the LCD monitor in one of
the following two ways:
1. In the upright position
2. Lay the screen face down
Table
To avoid damaging the screen face, place the protective sheet on
the table to lay the LCD on. The protective sheet was wrapped
around the LCD in the original packaging.
This device cannot be used or installed without the Tabletop Stand
or other mounting accessory. For proper installation it is strongly
recommended to use a trained, NEC authorized service person.
Failure to follow NEC standard mounting procedures could result
in damage to the equipment or injury to the user or installer. Prod-
uct warranty does not cover damage caused by improper instal-
lation. Failure to follow these recommendations could result in
voiding your warranty.
When using mounting accessories, other than NEC compliant and
approved, they must be VESA-compatible mounting method. NEC
strongly recommends using screws M6 size and 8mm in length. If
using screws longer than 8mm, check the depth of the hole.
(Recommended Fastern Force: 274 ~ 362N•cm)
NEC recommends using mounting interface that comply with
UL1678 standard in North America.
Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram to the right.
*Ambient temperature should be less than 40 deg C
Protective Sheet
To avoid falling down
Fasten the LCD monitor to a wall using a cord or chain which is
sufficient to support the weight of the LCD monitor (approx.
31.5kg).
Tabletop Stand
Clamper
Before moving the LCD monitor, the cord or chain should be re-
moved.
Screw Holes
Cord or Chain
Screw
*