Honda 2015 Ruckus NPS50 Owner's Manual page 64

60
Engine Oil
~ Changing
Engine Oil, Cleaning Strainer Screen
1. If the engine is cold, idle the engine for 3
to 5 minutes.
2. Turn the ignition switch off, and wait for
2 to 3 minutes.
3. Place your scooter on its center stand on
a firm, level surface.
4 . Place a drain pan under the drain bolt
and oil plug.
5.
Remove the oil fill cap/dipstick, drain bolt
and sealing washer to drain the oil.
6. Remove the oil plug, 0-ring, spring and
oil strainer screen and let the remaining
oil drain out.
~Discard
the oil at an approved
recycling center.
7. Clean the oil strainer screen.
8 . Check that the oil strainer screen and
sealing rubber are in good condition.
9. Replace the 0-ring and apply a thin coat
of engine oil to the new 0-ring before
installing it.
Sealing washer
c.E~ ~ ))H·_.
1 ·-r"!-·-~-
-u- .
?s·
------
' - ......._
___ _
Drain bolt