Remove Monitor Stand For Mounting - NEC MultiSync LCD1830 LCD1830 LCD1830 User Manual

Tilt
Grasp both sides of the monitor screen with
your hands and adjust the tilt as desired
(Figure TS.1).
Remove Monitor Stand
for Mounting
To prepare the monitor for alternate mounting
purposes:
1. Remove the connector
cover, hinge cover and
cable cover. (Figure R.1)
2. Disconnect all cables.
3. Place monitor face down
on a non-abrasive
surface.
(Place the screen on a
32 mm platform so that
hole of stand match to
screw location)
(Figure R.2).
4. Remove the 4 srcews
connecting the monitor to the
stand and lift off the stand
assembly (Figure R.2) the monitor
is now ready for mounting in an
alternate manner.
5. Connect the AC cord and signal
cable to the back of the monitor.
6. Reverse this process to reattach
stand.
Caution:To fulfil the safety requirements
the monitor must be mounted to
an arm which guaranties the
necessary stability under
consideration of the weight of the
monitor. The LCD monitor shall
only be used with an approved
arm (e.g. GS mark).
01b_English
English-6
6
Figure TS.1
Push
Figure R.1
Screws
Figure R.2
13.12.2000, 11:50 Uhr
Push