Operation - Makita TD0101 Instruction Manual

For European and North & South American
countries, Australia and New Zealand
A=12mm Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For other countries
To install these types of bits, follow
A=17mm
the procedure (1).
B=14mm
(Note) Makita bits are these types.
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
006349
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far as
it will go. Then release the sleeve to secure the bit.
Fig.5
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
Fig.6
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the sleeve,
•
the sleeve will not return to its original position and
the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.

OPERATION

Fig.7
NOTE:
The size of wood screw which can be fastened with
•
this tool may differ depending upon the type of
material to be fastened. Always perform a test
operation to determine the size of wood screw.
Holding the tool
Hold the tool only by the handle when performing an
operation. Do not touch the metal part.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
.
N m
(kgf.cm)
120
(1224)
100
(1020)
80
(816)
60
(612)
40
(408)
20
(204)
0
009619
.
N m
(kgf.cm)
100
(1020)
80
(816)
60
(612)
40
(408)
20
(204)
0
009620
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
When fastening screw M8 or smaller, carefully
•
adjust pressure on the switch trigger so that the
screw is not damaged.
Hold the tool pointed straight at the screw.
•
If you tighten the screw for a time longer than
•
shown in the figures, the screw or the point of the
driver bit may be overstressed, stripped, damaged,
5
Standard bolt
M14
M12
M14
M10
M12
M10
M8
M8
3.0
2.0
1.0
Fastening time (S)
High tensile bolt
M8
2.0
1.0
Fastening time (S)
M10
M10
M8
3.0