Sony HVR-HD1000J Service Manual page 269

3-1-4. Alignment Tapes
Use the alignment tapes shown in the following table.
Use tapes specified in the signal column of each adjustment.
Name
Tracking standard (XH2-1)
SW/OL standard (XH2-3)
Audio operation check
(XH5-3 (NTSC), XH5-3P (PAL))
System operation check
(XH5-5 (NTSC), XH5-5P (PAL))
Fig. 6-3-2 shows the 75% color bar signals recorded on the align-
ment tape for Audio Operation Check.
Note: Measure with video terminal (Terminated at 75 Ω)
For NTSC model
White (75%)
0.714 V
1 V
0.286 V
Horizontal sync signal
For PAL model
0.7 V
1 V
0.3 V
Horizontal sync signal
3-1-5. Output Level and Impedance
VIDEO OUT jack
Pin jack, 1 Vp-p, 75 Ω (ohms)
S VIDEO OUT jack
4-pin mini DIN
Luminance signal:
1 Vp-p, 75 Ω (ohms)
Chrominance signal:
0.286 Vp-p, 75 Ω (ohms) (NTSC)
0.300 Vp-p, 75 Ω (ohms) (PAL)
HVR-HD1000J/HD1000U/HD1000N/HD1000E/HD1000P/HD1000C
Use
Tape path adjustment
Switching position adjust-
ment
Audio system adjustment
Operation check
White (100%)
Q
I
Color bar signal waveform
White (100%)
Color bar signal waveform
Fig. 6-3-2 Color bar signal of alignment tapes
Burst signal
(75%)
0.286 V
0.3 V
(100%)
Burst signal
AUDIO OUT jack
Pin jack
Audio signal: 327 mV (at load impedance 47 kΩ (kilohms)),
Output impedance with less than 2.2 kΩ (kilohms)
COMPONENT OUT jack
Y: 1 Vp-p, 75 Ω (ohms)
P /P , C /C
B R B
6-115
Q Black
I
White
(100%)
Color bar pattern
Color bar pattern
: ± 350 mV, 75 Ω (ohms)
R