Sony HVR-HD1000J Service Manual page 251

Ver. 1.1 2007.12
3-29. Cam Gear Ass'y
1. Removal procedure
1) Remove the screw (special head screw M1.4 × 1.4) 1.
2) Remove the cam gear ass'y 2 from the cam gear shaft.
Apply grease
Apply grease when installing
Amount of grease: A ball of
grease of 1.0 mm diameter
Side of outside
Cam gear ass'y
Side of inside
Do not apply grease to the
locations other than those specified .
Make sure to follow the amount of
grease to be applied.
Cam gear assy
Key Points
in Re-assembling
HVR-HD1000J/HD1000U/HD1000N/HD1000E/HD1000P/HD1000C
1 Screw
(M1.4 × 1.4)
2 Cam gear ass'y
Dowel B
Cam gear assy
Mode gear assy
Dowel B
Cam gear assy
A
Mode slider assy
6-103
2. Attachment procedure
1) Apply grease on the specified locations of the cam gear ass'y 2.
Amount of grease: A ball of grease of 1.0 mm diameter.
2) Move the mode slider ass'y in the direction of arrow A as far
as it can go.
3) Align the gear phase of the mode gear ass'y and the cam gear
ass'y 2.
4) Install the cam gear ass'y 2 while engaging the dowel B of
the mode slider ass'y into the groove of the cam gear ass'y.
5) Install the screw (special head screw M1.4 × 1.4) 1.
Tightening torque: 0.04 ± 0.01 N•m (0.61 ± 0.1 kgf•cm)
Cam gear shaft
Mode gear ass'y