Sony HVR-HD1000J Service Manual page 13

1-6-2. E : 62 : 10 [Shift Lens Initializing Failure] Occurred
Connect the adjustment remote commander (RM-95 or NEW LANC JIG) and perform the following process.
Order Page Address Data
1 0 01
2 0 10
F
3 06
(7F)
F
4 06
(7F)
F
5 06
(7F)
F
6 07
(7F)
F
7 07
(7F)
F
8 07
(7F)
9 0 10
10 0 01
11
12 2 01
13 2 02
14 2 01
15
16
Note 1: Perform adjustment by referring to "Hall Adjustment" in "6. ADJUSTMENTS". After the adjustment, be sure to perform
"Angular Velocity Sensor Sensitivity Adjustment".
Note 2: When the lens block was replaced, execute the necessary adjustment items referring to "6. ADJUSTMENTS".
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
HVR-HD1000J/HD1000U/HD1000N/HD1000E/HD1000P/HD1000C
01
07
Read the data value and assume it as D
Change the data and check that it has been changed. If no value changes or if value is 00 or FF, inspect
the EEPROM (IC1802 of VC-500 board). If value changes, proceed to the order 5.
D Press PAUSE (Write) button.
06
Read the data value and assume it as D
Change the data and check that it has been changed. If no value changes or if value is 00 or FF, inspect
the EEPROM (IC1802 of VC-500 board). If value changes, proceed to the order 8.
D Press PAUSE (Write) button.
07
00
00
Perform "Hall Adjustment". (Note 1)
If the lens does not move at all when adjusting it, proceed to the order 12. When the adjustment ends,
proceed to the order 16. (Note 1)
2D Press PAUSE (Write) button.
Read the data value. If value is not 01, inspect the EEPROM (IC1802 of VC-500 board). When value is
01, proceed to the order 14.
00 Press PAUSE (Write) button.
Turn the power OFF and ON again.
Check that no error occurs. If an error occurs, replace the lens block (Note 2).
Procedure
.
06
.
07
1-6
ENGLISH JAPANESE
ENGLISH JAPANESE