Sony SDM-G76X Operating Instructions Manual page 41

x Automatic picture quality adjustment
function
When the monitor receives an input signal, it automatically
adjusts the picture's position and sharpness (phase/pitch), and
ensures that a clear picture appears on the screen (
Note
While the automatic picture quality adjustment function is activated, only
the 1 (power) switch will operate.
If the automatic picture quality adjustment function of this
monitor seems to not completely adjust the picture
You can make further automatic adjustment of the picture quality for the
current input signal (See AUTO ADJUST below).
If you still need to make further adjustments to the picture
quality
You can manually adjust the picture's sharpness (phase/pitch) and
position (horizontal/vertical position).
These adjustments are stored in memory and automatically
recalled when the monitor receives a previously input and
registered input signal.
x Make further automatic adjustments to the
picture quality for the current input signal
(AUTO ADJUST)
1 Press the MENU button.
The main menu appears on the screen.
2 Press the m/M buttons to select
press the OK button.
The SCREEN menu appears on the screen.
3 Press the m/M buttons to select AUTO ADJUST and
press the OK button.
The AUTO ADJUST menu appears on the screen.
4 Press the m/M buttons to select ON or OFF and
press the OK button.
• ON: Make the appropriate adjustments of the screen's
phase, pitch and horizontal/vertical position for
the current input signal and store them.
Note
When the monitor is turned on or the input signal is
changed, AUTO ADJUST makes the automatic
adjustments.
• OFF: AUTO ADJUST is not available.
Note
AUTO ADJUST works automatically when the input
signal is changed.
5
Press the m/M buttons to select
OK button.
Return to the menu screen.
x Adjust the picture's sharpness and position
You can adjust the picture's sharpness as follows. This
adjustment is effective when the computer is connected to the
page 19
).
monitor's HD15 input connector (analog RGB).
1 Set the resolution to 1280 × 1024 on the computer.
2 Load the CD-ROM.
3 Start the CD-ROM
4 Click "Adjust" and confirm the current resolution
5 Press the MENU button.
6 Press the m/M buttons to select
7 Press the m/M buttons to select PITCH and press the
(SCREEN) and
8 Press the m/M buttons until the vertical stripes
9 Press the OK button.
10 Click "Next".
11 Press the m/M buttons to select PHASE and press
and press the
15
(GB)
manually (PITCH/PHASE/H CENTER/
V CENTER)
For Windows User
When Auto run operates:
Select the area, language and model, and click DISPLAY
ADJUSTMENT TOOL (UTILITY).
(top value) and recommended resolution (bottom
value), and then click "Next".
Test pattern for PITCH appears.
The main menu appears on the screen.
press the OK button.
The SCREEN menu appears on the screen.
OK button.
The PITCH adjustment menu appears on the screen.
disappear.
Adjust so that the vertical stripes disappear.
The main menu appears on the screen.
If horizontal stripes are observed over the entire screen, adjust
the PHASE using the following procedures.
Test pattern for PHASE appears.
the OK button.
The PHASE adjustment menu appears on the screen.
(SCREEN) and