Additional Safety Instructions For Batteries And Chargers - Black & Decker CV1205 Original Instructions Manual

Additional safety instructions for
batteries and chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not expose the battery to heat.
u
Do not store in locations where the
u
temperature may exceed 40 °C.
Charge only at ambient temperatures
u
between 10 °C and 40 °C.
Charge only using the charger
u
provided with the appliance/tool.
When disposing of batteries, follow
u
the instructions given in the section
"Protecting the environment".
Do not damage/deform the battery
u
pack either by puncture or impact, as
this may create a risk of injury and fire.
Do not charge damaged batteries.
u
Under extreme conditions, battery
u
leakage may occur. When you notice
liquid on the batteries, proceed as
follows:
Carefully wipe the liquid off using a
u
cloth. Avoid skin contact.
In case of skin or eye contact, follow
u
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property.
In case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your Black & Decker charger
u
only to charge the battery in the
appliance/tool with which it was
supplied. Other batteries could burst,
causing personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
ENGLISH
If the supply cord is damaged, it must
u
be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.
Electrical safety
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger #
Your charger is double
insulated; therefore no earth
wire is required.
Fail safe isolating transformer.
The mains supply is electrically
separated from the transformer
output.
The charger automatically shuts
off if the ambient temperature
becomes too high. As soon as
the ambient temperature has
decreased, the charger will
$
resume operating.
The charger is intended for
indoor use only.
Features
1. On/off switch
1. Two-speed on/off switch (CV1205)
2. Release button
3. Dust bowl
4. Charging base
5. Filter cleaning wheel (CV9605/
CV1205)
6. Charging indicator
Fig. A
7. Crevice tool
8. Brush tool
7