Accessories; Water Filter Certifications - Kenmore 106.5178 Series Use & Care Manual

ICE AND WATER Possible Causes and/or Recommended Solutions
Water is leaking NOTE: After dispensing, a few additional drops of water are normal.
or dripping
Glass was not held under the dispenser long enough - Hold the glass under the dispenser for
from the dispenser
2 to 3 seconds after releasing the dispenser pad/lever.
New installation, or water filter was recently installed or replaced - Air in the water lines causes the water
dispenser to drip. Flush the water system to remove the air in the water lines. See "Water and Ice
Dispensers."
Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or pieces.
Water is leaking Water line connections are not fully tightened - Make sure all connections are firmly tightened. See
"Connect Water Supply."
from the
back of the
refrigerator
Water from the NOTE: Water from the dispenser is chilled to 50°F (10°C).
dispenser is
New installation - Allow 24 hours after installation for the water supply to cool completely.
not cool enough
Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool
(on some models)
completely.
Water has not been recently dispensed - The first glass of water may not be cool. Discard the first glass
of water dispensed.
Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold
water pipe. See "Water Supply Requirements."

ACCESSORIES

Replacement Parts:
To order stainless steel cleaner or replacement filters, call
1­800­4­MY­HOME and ask for the appropriate part number
®
listed below or contact your authorized Kenmore dealer.
Stainless Steel Cleaner and Polish:
Order Part #D22 M40083 R
Water Filter:
Order Part #9930 (P4RFKB2 or P4RFKB12)
Air Filter:
Order Part #W10335147A
Produce Preserver:
Order Part #W10335145A
22
WATER FILTER
CERTIFICATIONS