Specifications - Makita 3901 Instruction Manual

ENGLISH (Original instructions)
1-1. Pointer
1-2. Stopper
1-3. Adjusting screw
2-1. Lock lever
2-2. Angle guide
2-3. Knob
2-4. Scale
2-5. Pointer
3-1. Knob
3-2. Down
3-3. Up
3-4. Center of blade thickness
4-1. Fence
4-2. Lock lever
4-3. Angle scale
5-1. Lock lever
5-2. Pointer
5-3. Angle scale

SPECIFICATIONS

Blade size
Max. Cutting depth
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting crescent shaped slots for
the placement of flat wooden dowels or biscuit by a
plunging action.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Explanation of general view
5-4. Center of blade thickness
5-5. Base
6-1. Lock lever
6-2. Pointer
6-3. Angle scale
6-4. Set plate
6-5. Thickness of set plate
6-6. Center of blade thickness
6-7. Base
7-1. Set plate
8-1. Slide switch
9-1. Lock nut
9-2. Cutter blade
9-3. Inner flange
9-4. Clamp screw
9-5. Blade cover
10-1. Dust bag
10-2. Fastener
Model
Cutter blade
(Outer dia. x Width x Arbor dia.)
Circular saw blade
(Outer dia. x Arbor dia.)
Cutter blade
Circular saw blade
-1
)
Overall length
Net weight
Safety class
) : 87 dB(A)
pA
) : 98 dB(A)
WA
ENE013-1
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
ENF002-1
determined according to EN60745:
Work mode : rotation without load
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG102-3
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
5
10-3. Dust nozzle
18-1. For Frame Joint
19-1. For Edge-To-Edge Joint
21-1. For Corner Joint
22-1. For T-Butt Joint
24-1. For Frame Joint
25-1. For Edge-To-Edge Joint
31-1. Lock nut
31-2. Circular saw blade
31-3. Inner flange
31-4. Blade cover
32-1. Rubber facing
32-2. Blade cover
33-1. When trimming the wall panels
34-1. When trimming the ceiling panels
35-1. Limit mark
36-1. Brush holder cap
36-2. Screwdriver
3901
100 x 4 x 22 mm
110 x 20 mm
20 mm
25 mm
11,000
307 mm
3.0 kg
/II
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s or less
h
2
ENG224-2
vector sum)
ENG901-1