Specifications; Specific Safety Rules - Makita GA4030 Instruction Manual

ENGLISH
1. Shaft lock
2. Switch lever
3. Wheel guard
4. Screw
5. Bearing box

SPECIFICATIONS

Model
Depressed center wheel diameter
Spindle thread
Rated speed (n) / No load speed (no)
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. DOUBLE INSULATION
............. Wear safety glasses.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to grinder
safety rules. If you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
1. Safety Warnings Common for Grinding, Sanding,
Wire Brushing, or Abrasive Cutting-Off
Operations:
2. This power tool is intended to function as a
grinder, sander, wire brush or cut-off tool. Read all
safety warnings, instructions, illustrations and
specifications provided with this power tool.
4
Explanation of general view
6. Lever
7. Lock nut
8. Depressed center grinding wheel/
Multi-disc
9. RIng
GA4030
100 mm
M10
11,000 (min
266 mm
1.4 kg
END202-4
3. Operations such as polishing are not
4. Do not use accessories which are not specifically
5. The rated speed of the accessory must be at least
ENE048-1
ENF002-1
6. The outside diameter and the thickness of your
7. The arbour size of wheels, flanges, backing pads
GEB033-1
8. Do not use a damaged accessory. Before each use
10. Inner flange
11. Lock nut wrench
12. Exhaust vent
13. Inhalation vent
GA4530
115 mm
M14
-1
) 11,000 (min
266 mm
1.4 kg
/II
Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
recommended to be performed with this power
tool. Operations for which the power tool was not
designed may create a hazard and cause personal
injury.
designed and recommended by the tool
manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
equal to the maximum speed marked on the power
tool. Accessories running faster than their rated
speed can break and fly apart.
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
or any other accessory must properly fit the
spindle of the power tool. Accessories with arbour
holes that do not match the mounting hardware of the
power tool will run out of balance, vibrate excessively
and may cause loss of control.
inspect the accessory such as abrasive wheels for
chips and cracks, backing pad for cracks, tear or
excess wear, wire brush for loose or cracked
wires. If power tool or accessory is dropped,
inspect for damage or install an undamaged
accessory. After inspecting and installing an
accessory, position yourself and bystanders away
from the plane of the rotating accessory and run
the power tool at maximum no-load speed for
GA5030
125 mm
M14
-1
) 11,000 (min
266 mm
1.4 kg
-1
)