Declaration Of Conformity - Bosch 8-115 Original Instructions Manual

30 | English
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
30.06.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
1 609 929 L00 | (25.7.08)
Dr. Eckerhard Strötgen
Head of Product
Certification
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull
the mains plug.
Protection Guard for Grinding
machine, and turn the protection guard until it
can clearly be heard to engage.
Adjust the position of the protection guard 12 to
the requirements of the work process. For this,
press the release lever 1 upward and turn the
protection guard 12 to the required position.
Adjust the protection guard 12 in such a
manner that sparking is prevented in the di-
rection of the operator.
The protection guard 12 may be turned only
upon actuation of the release lever 1! Oth-
erwise the power tool may not continue to
be used under any circumstances and must
be taken to an after-sales service agent.
Note: The encoding keys on the protection
guard 12 ensure that only a protection guard
that fits the machine type can be mounted.
Place the protection guard
12 onto the spindle collar
as shown in the illustra-
tion. The triangle marks on
the protection guard must
correspond with the re-
spective marks on the gear
case.
Press the protection guard
12 onto the spindle collar
until the shoulder of the
protection guard is seated
against the flange of the
Bosch Power Tools