Warnings And Safety Instructions - Hitachi RB24E Handling Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Warnings and safety instructions

Pay special attention to statements preceded by the following words:
WARNING
Indicates a strong possibility of severe personal injury or loss
of life, if instructions are not followed.
CAUTION
Indicates a possibility of personal injury or equipment damage, if
instructions are not followed.
NOTE
Helpful information for correct function and use.
Operator safety
• IMPORTANT: A dust filter mask should be worn during operation.
• Always wear a safety face shield or goggles.
• Always wear heavy, long pants, boots and gloves. Do not wear
loose clothing, jewelry, short pants, sandals or go barefoot.
Secure hair so it is above shoulder length.
• Do not operate this tool when you are tired, ill or under the
influence of alcohol, drugs or medication.
• Never let a child or inexperienced person operate the machine.
• Wear hearing protection. Pay attention to your surroundings.
Be aware of any bystanders who may be signaling a problem.
Remove safety equipment immediately upon shutting off engine.
• Wear head protection.
• Never start or run the engine inside a closed room or building.
Breathing exhaust fumes can kill.
• Keep handles free of oil and fuel.
• Keep hands away from moving part or heated area.
• Do not grab or hold the unit by the blow pipe.
• When the unit is turned off make sure the engine has stopped
before the unit is set down.
• When operation is prolonged, take a break from time to time
so that you may avoid possible Hand-Arm Vibration Syndrome
(HAVS) which is caused by vibration.
WARNING
Antivibration systems do not guarantee that you will not
sustain Hand-Arm Vibration Syndrome (HAVS) or carpal tunnel
syndrome. Therefore, continual and regular users should
monitor closely the condition of their hands and fingers.
If any of the above symptoms appear, seek medical advice
immediately.
WARNING
If you are using any medical electric/electronic devices such
as a pacemaker, consult your physician as well as the device
manufacturer prior to operating any power equipment.
Unit / machine safety
• Inspect the entire unit/machine before each use. Replace
damaged parts. Check for fuel leaks and make sure all fasteners
are in place and securely tightened.
• Replace parts that are cracked, chipped or damaged in any way
before using the unit/machine.
• Make sure the safety guard is properly attached.
• Keep others away when making carburetor adjustments.
• Use only accessories as recommended for this unit/machine by
the manufacturer.
WARNING
Never modify the unit/machine in any way. Do not use your
unit/machine for any job except that for which it is intended.
Fuel safety
NOTE
• Empty the fuel tank before storing the tool. It is a must otherwise
fuel may corrode causing carburetor damage. It is recommended
that the fuel be emptied after each use. If fuel Is left In the tank,
store so fuel will not leak.
• Fuel contains highly flammable and it is possible to get the serious
personal injury when inhaling or spilling on your body. Always pay
G
attention when handling fuel. Always have good ventilation when
B
handling fuel inside building.
• Mix and pour fuel outdoors and where there are no sparks or
flames.
• Use a container approved for fuel.
• Do not smoke or allow smoking near fuel or the unit/machine or
while using the unit/machine.
• Wipe up all fuel spills before starting engine.
• Move at least 3 m away from fueling site before starting engine.
• Stop engine before removing fuel cap.
• Store unit/machine and fuel in area where fuel vapors cannot
reach sparks or open flames from water heaters, electric motors
or switches, furnaces. etc.
WARNING
Fuel is easy to ignite or get explosion or inhale fumes, so that
pay special attention when handling or filling fuel.
Blowing safety
• Operate power equipment only at reasonable hours-not
early in the morning or late at night when people might be
disturbed. Comply with times listed in local ordinances. Usual
recommendations are 9:00 a.m. to 5:00 p.m., Monday through
Saturday,
• Never direct discharge of air toward bystanders nor allow anyone
near the area of operation. Use care in directing discharge to
avoid glass enclosures, automobiles, etc.
• Stay alert for uneven sidewalks, holes in terrain or other unstable
condition when using the tool.
• Take all possible precautions when leaving the tool unattended
such as stopping the engine.
• Never operate the tool without guards, blow pipes or other
protective device in place. (If so equipped.)
• Use rakes and brooms to loosen debris before blowing.
• Keep others including children, animals, bystanders and helpers
outside the 15 m hazard zone. Stop the engine immediately if you
are approached.
• Always keep the engine on the right side of your body. ( Blower only)
• Keep firm footing and balance. Do not over-reach.
• Keep all parts of your body away from the muffler.
• Always carry a first-aid kit when operating any power equipment.
• Never start or run the engine inside a closed room or building
and/or near inflammable liquids. Breathing exhaust fumes can kill.
Maintenance safety
• Maintain the unit/machine according to recommended
procedures.
• Disconnect the spark plug before performing maintenance except
for carburetor adjustments.
• Keep others away when making carburetor adjustments.
• Use only genuine HITACHI replacement parts as recommended
by the manufacturer.
CAUTION
Do not disassemble the recoil starter. You may get a possibility of
personal injury with recoil spring.
Transport and storage
• Carry the unit/machine by hand with the engine stopped and the
muffler away from your body.
• Allow the engine to cool, empty the fuel tank, and secure the unit/
machine before storing or transporting in a vehicle.
• Empty the fuel tank before storing the unit/machine, It is
recommended that the fuel be emptied after each use. If fuel is
left in the tank, store so fuel will not leak.
• Store unit/machine out of the reach of children.
• Clean and maintenance the unit carefully and store it in a dry
place
• Make sure engine switch is off when transporting or storing.
If situations occur which are not covered in this manual, take
care and use common sense. Contact Hitachi Authorized Service
Centers if you need assistance.
GB-3

Advertisement

Table of Contents
loading

Table of Contents