Programming The Ch Rtn Button; Turning On Your Tv For The First Time - Toshiba 43L310U Manual

43L310U/ 49L310U/55L310U Toshiba 43"/49"/55" 1080p 60Hz LED TV

Programming the CH RTN button

You can use the SurfLock™ feature to temporarily
program a specific channel or video input to the
CH RTN button so you can return to the programmed
channel or input from any other channel or input.
Note
Your TV returns to the programmed channel
or input one time only. After you press
CH RTN, the programmed channel or input is
cleared and the CH RTN returns to it's normal
function.
1 Tune the TV to the channel or video input you
want to program to the CH RTN button.
2 Press and hold CH RTN until Memorized appears
on the screen. The channel or input has been
programmed to the CH RTN button. When you
press CH RTN, your TV tunes to the programmed
channel or input.
Turning on your TV for the
first time
The first time you turn on your TV, the Initial Setup
wizard opens. The wizard guides you through setting
up basic settings including the menu language, time
zone, picture mode, TV signal source, and the channel
list.
Note
You must select a language and Home or
Store mode. You cannot exit the Initial
Setup wizard until you make these
selections.
1 Make sure that you have:
• Installed the remote control batteries. (See
page 38.)
• Connected an antenna, cable TV, or satellite TV.
(See page 18 through 23.)
• Connected the power cord. (See page 37.)
2 Press (power) to turn on your TV. The Initial
Setup wizard opens.
3 Press or to highlight a language.
4 Press or to highlight Time Zone, press
to select your time zone, then press ENTER.
5 Press
then press ENTER.
For normal home use, you should select Home
mode. If you select Store mode, every time you
turn on your TV, it will be in Store mode. Store
mode is not an energy savings mode.
6 Press
press ENTER.
7 If you are using an antenna or connecting a cable
box directly to a wall jack, press ENTER again. Your
TV starts scanning for channels available in your
viewing area.
OR
If you connected a cable box or a satellite box,
press EXIT to close the wizard. You do not need to
scan for channels.
After the wizard closes, the Auto Tuning (Antenna)
menu opens with the first found channel
highlighted.
8 Press EXIT to close the menu.
or
www.tv.toshiba.com
or to highlight Home or Store mode,
or to highlight Antenna or Cable, then
39