Adjusting The Viewfinder Position; Using The Bkw-401 Viewfinder Rotation Bracket - Sony XDCAM PMW-500 Operation Manual

Viewfinder left-to-right positioning ring
2
Couple the viewfinder connector to the
VF connector (20-pin).
VF connector (20-pin)
Detaching the viewfinder
You can carry out this by following the attaching
procedure in reverse order, but there is an
additional action to take: when detaching the
viewfinder from the fitting shoe, pull up the
stopper.

Adjusting the Viewfinder Position

To adjust the viewfinder left-right position,
loosen the left-right positioning ring, and to adjust
the front-back position, loosen the front-to-back
positioning knob.
36 Attaching the Viewfinder
Stopper
Using the BKW-401 Viewfinder
Rotation Bracket
By fitting an optional BKW-401 Viewfinder
Rotation Bracket, you can rotate the viewfinder
out of the way so that your right leg does not hit
the viewfinder while you are carrying the
camcorder.
1
2
Viewfinder left-to-right positioning ring
Viewfinder front-to-back positioning knob
Loosen the front-to-back viewfinder
positioning levers and the front-to-back
viewfinder positioning knobs, and then
pull the viewfinder slide assembly
forward.
Using a 2.5 mm diameter hexagonal
wrench, detach the viewfinder slide
assembly.