Troubleshooting - Epson OT-CH60II User Manual

Note:
❏
Turn ON/OFF the charger only when the power plug of the AC adapter is connected
with the power outlet.
❏
When you switch off the charger and then switch it on again, check that
the (Power) LED has gone off before you switch it on.
❏
Remove the battery pack from the battery holders prior to leaving battery charger
unused for an extended period.
Notes on Charging Time
❏
Charging time will be Approx. 2.5 hours. This is the time taken to charge a
battery pack that is completely discharged.
❏
Actual charging time may differ from the time above, depending on the
temperature and the condition of the battery pack.
Cleaning the charger Case
Be sure to turn off the charger, and wipe the dirt off the charger case with a dry cloth or a
damp cloth.
CAUTION:
Never clean the product with alcohol, benzine, thinner, or other such solvents.
Doing so may damage or break the parts made of plastic and rubber.

Troubleshooting

❏
If the Charge LED does not light or flash, be sure that a battery pack is
attached firmly. If it is not attached firmly, charging cannot be done correctly.
❏
If the Charge LED keeps flashing, follow the steps below:
If the Charge LED flashes again, replace
the battery pack with an another one.
If the Charge LED flashes again, there
might be a problem in the battery charger.
Contact your dealer or Seiko Epson service center for advice on a
product that seems to have problems.
❏
If your printer does not operate correctly even if a sufficiently charged battery
pack is installed, the battery pack or the battery charger may be defective.
Contact your dealer or a Seiko Epson service center for advice.
10 OT-CH60II User's Manual
Remove the battery pack that was being
charged and then reattach it.
If the Charge LED is lit and does not flash again
and the Charge LED goes off when the charging
time has passed, there is no problem.
If the Charge LED is lit and does not flash again
and the Charge LED goes off when the charging
time has passed, there might be a problem in the
previous battery pack.