µ PD78214 Sub-Series
5.3.1 Hardware Configuration
Fig. 5-6 shows the configuration of port 2
WR
RD
RD
RD
Note P20 or P21 does not have a circuit enclosed in a dotted box.
5.3.2 Setting the Input Mode and Control Mode
Port 2 is an input-only port.
There is no register to specify an input mode for port 2. Port 2 is always ready to receive control signals. A register
such as a control register in the hardware is used to specify what control signal to receive.
5.3.3 Operation
Port 2 is an input-only port, and the level of each pin of it can be read and tested.
For P20 through P27, the level from which noise has be removed can be read and tested. See Chapter 11 for
removing noise.
64
Fig. 5-6 Block Diagram of Port 2
PUO
PUO
P2n
Interrupt and
Edge
control signals
detector
P27
SI input
3-wire serial
I/O mode
Pull-up resistor option register
PUO2
V
DD
P2n
n = 0, 1, 2, ···, 6
P27