Black & Decker LPP120 Instruction Manual page 9

3.Ifthebattery p ack does notcharge p roperly:
a.Check c urrent atreceptacle byplugging ina lamp orother
appliance
b.Check t osee if receptacle isconnected toa light s witch
which t urns power offwhen youturn outthelights.
c.Move charger andbattery p ack toa location where t he
surrounding airtemperature isapproximately 60°F and 80°F
(16 °-27°C)
d.Ifcharging problems persist, take thetool, b attery p ack and
charger toyourlocal s ervice center.
4.The battery p ack should b erecharged when itfails toproduce
sufficient power onjobs which were easily d one previously. DO
NOT CONTINUE touseunder these conditions. Follow thecharging
procedure. Youmay also charge a partially used pack whenever
youdesire w ith noadverse affect o nthebattery p ack.
5.Foreign m aterials ofaconductive nature s uch as,butnotlimited
to,steel wool, aluminum f oil, o ranybuildup o fmetallic particles
should b ekept a way f rom charger cavities. Always u nplug t he
charger from thepower s upply w hen there isnobattery p ack inthe
cavity. Unplug c harger before a ttempting toclean.
6.Donotfreeze o rimmerse charger inwater o ranyother l iquid.
z'_WARNING:
Shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
_WARNING:
Make certain the lock-off
button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery
pack into tool until an audible click is heard
(figure la).
TO REMOVE BATTERY PACK: Depress the
battery release button in the back of the battery
pack and pull battery pack out of tool
(figure lb).
_WARNING:
Read and understand all instructions. Failure to
follow all instructions listed below may result in electric shock, fire
and/or serious personal injury.
installing and Removing Saw Chain
Z_WARNING:
Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
before performing the following operations. Failure to do this
could result in serious personal injury.