Page 2
It is the owner’s sole responsibility to install and use the instrument in such a manner that will not cause accidents, personal injury or property damage. Navman NZ Limited disclaims all liability for any use of this product in a way that may cause accidents, damage or that may violate the law.
Section 1 - General Information ... 5 1-1 Features ... 5 1-2 Customizing Your Navman VHF Radio ... 6 1-3 How to Display and Navigate Menus ... 6 1-4 How to Enter Alphanumeric Data ... 6 1-5 LCD Symbols and Meanings ... 6 1-6 Basic Operation and Key Functions...
Page 4
C-2 USA Channel Chart ... 42 C-3 CANADA Channel CHART ... 45 C-4 EU Channel Chart ... 48 Special Channels 7... 50 Appendix D - MMSID & License Information... 51 Appendix E - How to Contact Us... 52 NAVMAN VHF 7000, 7100US, 7100EU Operation Manual...
1-1 Features Congratulations on your purchase of a Navman VHF 7000, 7100US, or 7100EU marine band VHF radio. All of these models provide the following useful features: • prominent channel display • adjustable contrast settings for the LCD • adjustable keypad backlighting for easy night-time use •...
If you make an error, press - until < is displayed, then press ENT to backup and correct the entry. 1-5 LCD Symbols and Meanings This simulation shows the locations of all the following information symbols: VHF 7000, 7100US, 7100EU Operation Manual NAVMAN...
Page 7
A transmission on Channel 16 is being made at high power using the International channel bank. Channel 16 is set as the Priority channel. It is also set as favourite channel 1. There is an incoming DSC call so the receiver is busy. VHF 7000, 7100US, 7100EU Operation Manual NAVMAN...
The default is Channel 16. To make Channel 09 the priority channel, hold down 16/9 until a beep sounds and 09 is displayed. Priority Channel. VHF 7100EU and VHF 7000 only. Also on the microphone. Press to cancel all other modes and to tune into the priority channel, Channel 16, on high power.
Page 9
LCD along with the last used channel. All the channel charts are shown in Appendix C. Channel Bank. 7000 only. Press to toggle between channel banks. Note that the channel banks available are dependent upon your VHF radio model. The selected channel bank is displayed on the LCD along with the last used channel.
Page 10
Hold down to enter the DSC Setup Menu and customize your radio. See Section 4. MENU Radio menu. 7000 only. Press to enter the Radio Menu and customize your NAVMAN VHF radio. See Section 3. DISTRESS Send DSC Distress Call. 7100US & 7100EU only. See Section 6.
DSC SETUP RADIO SETUP GPS SIM RESET Sections 1-3 and 1-4 explain how to navigate around the menu and enter, save and change data. VHF 7000, 7100US, 7100EU Operation Manual MANUAL SETTING USER MMSID GROUP SETUP INDIV REPLY DSC FUNC...
Steps 2 thru 6. Otherwise, press ESC to exit. ENTER NAME ENTER NAME –––––––––––– ENTER MMSID ENTER MMSID 123456789 ––––––––– ALEX >EDIT DELETE NAVMAN 123456789 >STORE EDIT NAME ALEX ALEX 111223344 EDIT MMSID >STORE 112233445 VHF 7000, 7100US, 7100EU Operation Manual CANCEL CANCEL...
LOCAL/DIST The microphone keypad backlighting is either ON or OFF. >BACKLIGHT Use CONTRAST to set the contrast level for the LCD. CONTRAST VHF 7000, 7100US, 7100EU Operation Manual EDIT MANUAL NEW >DELETE ALEX sensitivity and the menu is displayed again.
2-5-2 Local Time (TIME OFFSET) The local time can be set by entering the time offset between UTC and local time as follows. setting. setting. MANUAL LL ––’ ––’ ––––N ––’ ––’ ––––W MAN ––:––UTC NAVMAN VHF 7000, 7100US, 7100EU Operation Manual...
2-5-4 Time Display Options (TIME DISPLAY) If you have entered the time manually as described in the previous sections, the time is always shown on the screen with the prefix M. VHF 7000, 7100US, 7100EU Operation Manual GPS/DATA >TIME OFFSET...
In this example, OFF has been selected and the screen no longer shows the vessel position. In this example, ON has been selected and so the screen shows the bearing and speed. VHF 7000, 7100US, 7100EU Operation Manual...
>RESET 1. Select RESET. The radio asks for confirmation. 2. Select YES to reset the radio and return to the menu. VHF 7000, 7100US, 7100EU Operation Manual desired. Whenever the GPS Simulator is turned ON (on), simulated Speed Over Ground (SOG), Course Over Ground (COG), and LL position appear on the screen.
It can be a maximum of 12 characters. To delete the channel name, select DELETE and press ENT. CH NAME TELEPHONE EDIT CH NAME PHONE1 >YES NAVMAN TELEPHONE >EDIT DELETE VHF 7000, 7100US, 7100EU Operation Manual over the...
CH16 and CH09 as well as the working channel, as follows: RADIO SETUP BEEP VOLUME INT SPEAKER >WATCH MODE VHF 7000, 7100US, 7100EU Operation Manual RING VOLUME >HIGH 1. Select INT SPEAKER >ON 2.
2. Select CHECKSUM ON (on) or OFF >ON NAVMAN RADIO SETUP, ALERT. ENT to enable the setting and return to the menu. PORT. (off) then press ENT to enable the setting and return to the menu. VHF 7000, 7100US, 7100EU Operation Manual then...
2. If this is the first time that you are entering your user MMSID, a dashed line appears. Enter your user MMSID along the dashed line. Press ENT to confirm each correct entry and to move to the next digit. VHF 7000, 7100US, 7100EU Operation Manual 187654321 INPUT USER...
5. Press ENT to store the changes and return to the GROUP SETUP screen. GROUP NAME –––––––––––– 000000000 GROUP MMSID 0–––––––– EDIT NAME FISHER1 DELETE EDIT MMSID 012345678 NAVMAN FISHER1 012345678 >STORE CANCEL FISHER2 012345678 >STORE CANCEL VHF 7000, 7100US, 7100EU Operation Manual...
>ATIS MMSID ATIS MMSID 923456789 >STORE CANCEL VHF 7100EU only. An ATIS MMSID always starts with the number 9. To enter or edit your ATIS MMSID: VHF 7000, 7100US, 7100EU Operation Manual DELETE GROUP EDIT FISHER2 >YES 1. Select 2. Select AUTO for an automatic response,...
It is not possible to have both ATIS ON (on) and DSC ON (on) simultaneously. When you enable one, the other will turn OFF (off). If DSC and ATIS are both OFF (off), DSC will have to be switched ON (on) for normal DSC operation. NAVMAN ATIS VHF 7000, 7100US, 7100EU Operation Manual...
Show the details of the 20 most recent incoming calls. See Section 5-2-7. Show the details of the 10 most recent distress calls. See Section 5-2-8. Request the LL position of a buddy. See Section 5-2-9. NAVMAN VHF 7000, 7100US, 7100EU Operation Manual...
Press ENT to send an acknowledgement or ESC to cancel. ENTER –> ACK ESC –> EXIT The VHF 7100US will automatically send an acknowledgement to the requesting radio within 10 seconds of receiving the call. VHF 7000, 7100US, 7100EU Operation Manual MANUAL MMSID 0–––––––– BOBBY D REBECCA T...
MMSID of the vessel in Distress, the second screen shows the nature of the emergency (if specified) and the MMSID of the vessel that relayed the Distress Call. 3. Set the channel and continue as explained in Section 5-2-1. VHF 7000, 7100US, 7100EU Operation Manual VHF7100 >CALL BACK DELETE...
Urgency or Safety priority (see Section 5-3-1) Urgency, Safety, or Routine priority (see Section 5-3-2) Routine priority only (see Section 5-3-3) Routine priority only (see Section 5-3-4) Routine priority only (see Section 5-3-5) NAVMAN LL REQUEST CALLING... VHF 7000, 7100US, 7100EU Operation Manual...
MMSID. 2. Monitor the working channel for an announcement from the calling vessel. VHF 7000, 7100US, 7100EU Operation Manual to cancel the alert. The radio automatically selects CH16. The priority level and the user MMSID are displayed on the screen.
If enhanced LL position information is available from your buddy, this is shown on the screen until the screen display changes. NAVMAN VHF 7000, 7100US, 7100EU Operation Manual...
Press ESC if you need to cancel the distress call. This is the only key that operates in distress mode. VHF 7000, 7100US, 7100EU Operation Manual DISTRESS CALL >PIRACY HOLD DISTRESS 2 SECONDS..
ACK). 1. An alert sounds when a distress call RCV: DISTRESS 10:34 UTC 82º50.003'N 27º45.543'W NAVMAN (DISTRESS!) is received. Press any key to cancel the alert. You do not need to send an acknowledgement. VHF 7000, 7100US, 7100EU Operation Manual...
MMSID and NAME directory: TRANSMITTER Frequency: Output power: Transmitter protection: VHF 7000, 7100US, 7100EU Operation Manual 13.6 V DC. 6A at 25W Tx / 1.5A at 1W Tx Less than 250 mA in standby International, USA (country specific) 16K0G3E (FM)
Page 36
FSTN 4 x 12 character SO-239 (50 ohm) -15ºC to +50ºC JIS-7 161(W) x 75(H) x 147(D) mm - without bracket 1.29 kg (2.8 lbs) - without microphone +/- 10ppm 4800 baud NMEA NAVMAN VHF 7000, 7100US, 7100EU Operation Manual...
Page 37
Residual Noise level: Audio output power: Compass safe distance: Specifications are subject to change without notice. VHF 7000, 7100US, 7100EU Operation Manual Yes - 20 individual and 10 distress Yes (VHS 7100US) Yes - 20 numbers & group 156.025 - 157.425MHz...
Check the polarity of the GPS cable. c) Check the baud rate setting of the GPS if applicable. The baud rate setting should be 4800 and parity should be set to NONE. VHF 7000, 7100US, 7100EU Operation Manual NAVMAN...
157.200 161.800 Public Correspondence, Duplex 157.250 161.850 Public Correspondence, Duplex 157.300 161.900 Public Correspondence, Duplex 157.350 161.950 Public Correspondence, Duplex 157.400 162.000 Public Correspondence, Duplex VHF 7000, 7100US, 7100EU Operation Manual SHIP SHIP NAVMAN SHIP NAME TAG SHORE TELEPHONE TELEPHONE TELEPHONE...
Page 40
157.375 161.975 Public Correspondence, Duplex 157.425 162.025 Public Correspondence, Duplex SHIP SHIP SHIP ------ ------ NAVMAN VHF 7000, 7100US, 7100EU Operation Manual NAME TAG TELEPHONE PORT OPS PORT OPS PORT OPS TELEPHONE PORT OPS PORT OPS BRIDGE COM SHIP - SHIP...
Page 41
3. Channel 70 is designated for use exclusively for Digital Selective Calling (DSC), such as Distress, Safety, and Ship Calls. No voice communication is allowed on CH70. 4. The INTERNATIONAL mode is not legal for use in U.S. or Canada waters. VHF 7000, 7100US, 7100EU Operation Manual TRAFFIC TYPE NAVMAN...
157.200 161.800 157.250 161.850 25B RX Only 161.850 157.300 161.900 157.350 161.950 157.400 162.000 VHF 7000, 7100US, 7100EU Operation Manual TRAFFIC TYPE Public Correspondence, Duplex No Public Correspondence, Duplex No Public Correspondence, Duplex No Canadian Coast Guard, SAR Port Operations, VTS in Selected...
Page 47
6. Channel 70 is designated for use exclusively for Digital Selective Calling (DSC), such as Distress, Safety, and Ship Calls. No voice communication is allowed on CH70. 7. The CANADA mode is not legal to use in U.S. waters. VHF 7000, 7100US, 7100EU Operation Manual TRAFFIC TYPE NAVMAN...
PORT OPS/VTS SAFETY PORT OPS COMMERCIAL CALLING COMMERCIAL PORT OPS/VTS BRIDGE COM PORT OPS/VTS PORT OPS DISTRESS PORT OPS SHIP - SHORE PORT OPS PORT OPS PORT OPS TELEPHONE TELEPHONE TELEPHONE TELEPHONE TELEPHONE TELEPHONE VHF 7000, 7100US, 7100EU Operation Manual...
Page 49
157.125 161.725 157.175 161.775 157.225 161.825 157.275 161.875 157.325 161.925 157.375 157.357 157.425 157.425 VHF 7000, 7100US, 7100EU Operation Manual TRAFFIC TYPE Public Correspondence, Duplex No Port Operations, Duplex Port Operations, Duplex Port Operations, Duplex Public Correspondence, Duplex No Port Operations, Duplex...
Depending upon your location, you may need a radio station license for the VHF 7100. You may also need an individual operator’s license. Navman NZ recommends that you check the requirements of your national radio communications authorities before operating DSC functions.