Download Print this page

Additional Safety Instructions For Batteries And Chargers - Black & Decker KC460LN Original Instructions Manual

Hide thumbs

Advertisement

Table of Contents
ENGLISH
Even with the application of the relevant safety
regulations and the implementation of safety de-
vices, certain residual risks can not be avoided.
These include:
Injuries caused by touching any rotating/

moving parts.
Injuries caused when changing any parts,

blades or accessories.
Injuries caused by prolonged use of a tool.

When using any tool for prolonged periods
ensure you take regular breaks.
Impairment of hearing.

Health hazards caused by breathing dust

developed when using your tool (example:-
working with wood, especially oak, beech
and MDF.)
Vibration
The declared vibration emission values stated in
the technical data and the declaration of conformity
have been measured in accordance with a standard
test method provided by EN 60745 and may be used
for comparing one tool with another. The declared
vibration emission value may also be used in a pre-
liminary assessment of exposure.
Warning! The vibration emission value during actual
use of the power tool can differ from the declared
value depending on the ways in which the tool is
used. The vibration level may increase above the
level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to protect
persons regularly using power tools in employment,
an estimation of vibration exposure should consider,
the actual conditions of use and the way the tool is
used, including taking account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle in addition
to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Additional safety instructions for
batteries and chargers
Batteries
Never attempt to open for any reason.

Do not expose the battery to water.

Do not expose the battery to heat.

6
Do not store in locations where the temperature

may exceed 40 °C.
Charge only at ambient temperatures between

10°C and 40 °C.
Charge only using the charger provided with the

appliance/tool.
When disposing of batteries, follow the instruc-

tions given in the section "Protecting the envi-
ronment".
Do not damage/deform the battery pack either

by puncture or impact, as this may create a risk
of injury and fi re.
Do not charge damaged batteries.

Under extreme conditions, battery leakage may

occur. When you notice liquid on the batteries
carefully wipe the liquid off using a cloth. Avoid
skin contact.
In case of skin or eye contact, follow the instruc-

tions below.
Warning! The battery fl uid may cause personal
injury or damage to property. In case of skin con-
tact, immediately rinse with water. If redness, pain
or irritation occurs seek medical attention. In case
of eye contact, rinse immediately with clean water
and seek medical attention.
Chargers
Your charger has been designed for a specific
voltage. Always check that the mains voltage cor-
responds to the voltage on the rating plate.
Warning! Never attempt to replace the charger unit
with a regular mains plug.
Use your Black & Decker charger only to charge

the battery in the tool with which it was supplied.
Other batteries could burst, causing personal
injury and damage.
Never attempt to charge non-rechargeable bat-

teries.
If the supply cord is damaged, it must be re-

placed by the manufacturer or an authorised
Black & Decker Service Centre in order to avoid
a hazard.
Have defective cords replaced immediately.

Do not expose the charger to water.

Do not open the charger.

Do not probe the charger.

The appliance/tool/battery must be placed in

a well ventilated area when charging.
The charger is intended for indoor use
only.
Read the instruction manual before use.

Advertisement

Table of Contents
loading