Talking And Listening; Talk Range; Monitoring Channel Activity; Selecting A Radio Channel - Motorola XTB446 Instruction Manual

TALKING AND LISTENING

Your radio has 8 channels and 38 interference eliminator codes.
If you are in a group and you wish to talk to each other, all radios
must be set to the same channel and code. If you experience
interference and need to change channel, ensure that you
change the channel and code of all radios in your group. To talk
to others using the radio:
1. Hold radio 5 to 7 centimetres from mouth.
2. Press and hold PTT and speak into the microphone. The
is displayed continuously whilst transmitting.
3. After speaking, release PTT. You can now receive incoming
calls. Whilst receiving, the

Talk Range

Your radio has been designed to maximize performance and
improve transmission range in the field. It is recommended that
you do not use the radios closer than 1.5 metres apart, to avoid
interference.
Talk range depends on the terrain. It will be affected by concrete
structures, heavy foliage and by operating radios indoors or in
vehicles.
Optimal range occurs in flat, open areas, with up to 8 kilometres
of coverage, if possible. Medium range occurs when buildings
and trees are in the way. Minimal range occurs when dense
foliage and mountains obstruct the communication path.
Optimal Range
Outdoors
Flat, open areas Buildings or trees.
4
is displayed.
Medium Range Minimal Range
Outdoors Outdoors
Dense foliage or
Also near mountains. Also
residential inside some
buildings buildings

Monitoring Channel Activity

It is good radio etiquette to monitor the channel for activity before
you transmit, to ensure that you do not interrupt other users
already on the channel.
1. To monitor briefly, press and release MON.
A flashing will be displayed. If you hear static, the channel
is clear for use. Obstacles that block the signal path may
affect the strength of the incoming signal.
2. To monitor continuously, press and hold MON for 2 seconds.
The will continue to flash.
Both the static noise and any signals will be heard.
3. To turn the monitor off, press MON, the
displayed.

Selecting a Radio Channel

1. Press CH/SCAN. The channel number will begin to flash.
2. Use the VOL/CH side button (+) or (-) to increase or
decrease the displayed channel number.
3. Press CH/SCAN to set the channel.
Interference Eliminator Code
Interference eliminator codes help minimize interference by
providing you with a choice of code combinations.You can
specify a different code for each channel. each of the channels,
1-8
, may have any one of the codes,
indicates no code selected and your radio can receive a signal
regardless of the code setting on the transmitting radio.
Note:
Handsets with different interference eliminator codes
will not be able to communicate with each other.
1. Press SEL/ . The code number begins to flash.
2. Use the VOL/CH side button (+) or (-) to increase or
decrease the displayed code number.
3. Press SEL/ 4 times to confirm the new code.
will no longer be
00-38 00
, selected. Code