Black & Decker BDX2700 Instruction Manual page 11

J. Pump Inlet
K. Quick Connect Nozzles
L. On Board Detergent
(BDX3100 only): Feeds cleaning
agents into the pump to mix with
the water. See how To Apply
Chemicals/Cleaning
instructions in Operation section.
BASIC ELEMENTS Of AN
ENGINE
Refer to the Engine Owners Manual
for location and operation of engine
controls.
Choke Control: Opens and closes
carburetor choke valve.
Starter Grip: Pulling starter grip
operates recoil starter to crank engine.
Engine Switch: Enables and disables
ignition system.
ASSEmbLY INSTrUcTIONS
(FIG. 14–16)
1. Locate and remove all loose parts
from the carton.
2. Cut four corners of the carton from
top to bottom and lay the panels
flat.
3. Slide the handle assembly (G)
onto the frame (H) and secure with
saddle bolts and knobs.
14
G
h
NOTICE: Risk of personal injury. Avoid
placing hands between handle and
frame when assembling to prevent
pinching.
4. Remove the
connect nozzles (K) from the
plastic bag and insert them into
correct grommet on the nozzle
holder. Nozzles are color coded to
match colored nozzles on label (Q).
Tank
Solvents
5.
6.
NOTE: The pump on this unit is
maintenance free and requires no oil.
If there is a problem with the pump,
contact our Customer Service Group on
www.power-washer.us as soon as
possible.
NOTICE: The engine is shipped without
oil. Before starting engine, add the oil
provided. Damage to the engine will
occur if the engine is run without oil,
this damage will not be covered under
warranty.
colored quick-
11 - ENG
14A
K
Q
Connect wand (E) to gun (D).
Tighten securely.
15
D
Attach high pressure hose (C) to
gun (D). Tighten se cure ly.
16
D
C
E