KitchenAid 740-0781 Installation Instructions And Use & Care Manual page 28

2. Remove the screw and clip that hold the burner in place.
Remove gas burner from the grill.
A
A. Clip
3. Use a flashlight to inspect into the burner through the burner
inlet to ensure there is no blockage. If any obstruction is seen,
use a metal coat hanger that has been straightened to clear them.
4. After inspecting the inside of burner for blockage, reassemble
burner by sliding the middle tube of the gas burner over the gas
orifice.
A
A. Burner/orifice connection
5. Reattach gas burner using screw and clip.
ROTISSIERE BURNER
Cleaning Method:
1. Light the rotisserie burner. See the "Using Your Rotisserie Burner"
section.
2. Close the grill hood.
3. Leave the burner on high for approximately 30 minutes.
4. Turn knob to OFF and let cool completely.
5. Brush off ash particles from the rotisserie burner.
28
INFRARED SEARING BURNER
Cleaning Method:
1. Light the infrared searing burner. See the "Using Your Infrared
Searing Burner" section.
2. Close the grill hood.
3. Leave the burner on high for approximately 30 minutes.
4. Turn knob to OFF and let cool completely.
5. Remove the grill grate and brush off ash particles from the sear
burner cover plate.
6. Replace the grill grate.
GREASE CUP
A. Clip
IMPORTANT: The grease cup should only be removed when grill is
completely cool.
The grease cup collects grease and food particles that fall through the grill.
Cl ean often to avoid grease buildup.
Cleaning Method:
Remove cup and set on a flat surface.
■
Wipe excess grease with paper towels.
■
Mild detergent and warm water. Rinse and dry thoroughly.
■
Replace cup
■
KNOBS AND FLANGE AREA AROUND KNOBS
IMPORTANT: To avoid damage to knobs or flange area around knobs,
do not use steel wool, abrasive cleaners, or oven cleaner.
Do not soak knobs.
Cleaning Method:
Mild detergent, a soft cloth and warm water.
■
Rinse and dry.
■
CONTROL PANEL GRAPHICS
IMPORTANT: To avoid damage to control panel graphics, do not use
steel wool, abrasive cleaners or oven cleaner.
Do not spray cleaner directly onto panel.
Cleaning Method:
Clean around the burner labels gently; scrubbing may remove
■
printing.
Mild detergent, soft cloth and warm water.
■
Rinse and dry.
■