Installing Your Morsø Stove; Unpacking The Stove; Installing The Stove; Chimney Sweeping - Morso O4 Instructions For Installation And Use Manual

1.0 InSTALLIng yoUR MoRSØ SToVE

1.1 Unpacking the stove

Carefully lift the stove from the wooden pallet and set it carefully in place.
We recommend that two people perform the assembly and installation procedure.
Ø4 weighs 80 kg, Ø6 weighs 04, kg and Ø8 weighs 32 kg.
The stove is intended for intermittent use.

1.2 Installing the stove

The stove and chimney installations MUST comply to all current National and Local Building
Regulations; your approved Ø-Collection dealer or your local building control officer can advise
regarding this. Ultimately, it is you and your installer who is responsible that the installation
complies.

1.3 Chimney sweeping

It may also be wise to consult your local chimney sweep before installing the stove. After your
stove has been installed, it is advisable to have the chimney checked and swept at least once
a year. In any case, if your chimney has not been used for some time, it should be inspected for
deterioration, bird nests, etc. before it is put back into use.
1.4 Stove placement/clearance requirements
Clearance requirements apply only if the stove is placed near to combustible materials.
Permitted clearances to combustible materials are also indicated on the data plate on the rear
of the stove.
3