Step 1 Remove the 4 screws, and push the Hook in.
Step 2 Lift up the Upper Base Ass'y, and pull it out to the direc-
tion of arrow.
10.17.2. Replacement of Tray
• Refer to "Disassembly of BD Drive".
• Refer to "Disassembly of Upper Base Assembly".
Step 1 Insert the Paper Clips, etc. into the hole of the bottom
side, and slide it to the direction of arrow until it can be.
Step 2 Pull the Tray to the direction of arrow until it can be.
Step 3 Insert the Paper Clips, etc. into the hole of the Tray at 45
degrees, and lean it to the direction of arrow with pushing the
dotted point of the tray forward.
Then the one side of the tray is come off from the Drive.
Step 4 Insert the Paper Clips, etc. into the Tray as below figure,
lift up the lever using the Eject Pin while pushing the dotted
point of the Tray.
And remove the Tray.
67