Kenwood SJM610 Instruction Manual page 5

Normal Kettle Operation
1 Plug in and the display will
be blank.
2 Press the ON/OFF button once
and the button will light up and
100°C will be shown on the
display screen.
Note: The default temperature
is always 100°C.
3 Press the ON/OFF button again
and the button will flash
constantly and the water will
start to boil.
4 At the end of the boiling cycle
the kettle will switch off
automatically with an audible
alert and 100°C will flash on
the display screen.
5 To switch off the kettle manually
press the ON/OFF button.
• If the ON/OFF button has only
been pressed once after
plugging in the 2nd press will
start heating the water. The
button will need to be
pressed 3 times to switch off.
NOTE:
• Once the boiling cycle has finished the kettle will
automatically switch off after 30 seconds. The
display screen will switch off and the kettle will go
into standby mode.
• If the kettle is removed from the powerbase at any
time the kettle will switch off automatically and go
into standby mode. Press the ON/OFF button to
reset.
• The kettle will automatically switch off if no function
has been selected within 30seconds.
• Always unplug the kettle when not in use.
Variable Temperature Feature
1 The temperature can be set
between 70, 75, 80, 85, 90,
95 or 100°C so that the most
suitable temperature can be
selected (Refer to the
"Recommended Temperature
Setting Chart").
2 Press the ON/OFF button once
and the button will light up and
100°C will be shown on the
display screen.
Note: The default temperature
is always 100°C
3 To select the desired
temperature press either the
(-) or (+) button until the
required temperature is shown
on the display screen.
• The Keep Warm feature
will not operate if 100°C
is selected.
4 Press the ON/OFF button
again and the button will flash
continuously and the water
will start to heat.
5 At the end of the heating cycle
the kettle will switch off
automatically with an audible
alert and the selected
temperature will flash on the
display screen.
• If the heating operation is manually stopped or the
kettle is removed from the powerbase the display will
show the last selected temperature.
• If the kettle is unplugged the display screen will
default to 100°C.
Recommended Temperature Setting Chart
This is for guidance only and temperatures
can be selected for personal preference.
Temp Setting
70°C
75°C
80°C
85°C
90°C
95°C
100°C
3
Recommended for
White tea
Green tea
Jasmine tea
Oolong tea
Instant coffee
Herbal teas and infusions
Black
Peppermint
Camomile
Instant drinks where
boiled water
recommended.