Download Print this page

Black & Decker BDCS36G User Manual page 8

Hide thumbs Also See for BDCS36G:

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
ENGLISH
$
The charger is intended for
indoor use only.
Read the instruction manual
before use.
#
Your charger is double insu-
lated; therefore no earth wire
is required. Always check that
the mains voltage corresponds
to the voltage on the rating
plate. Never attempt to replace
the charger unit with a regular
mains plug.
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised Black & Decker Service Centre
in order to avoid a hazard.
This tool includes some or all of the following
features.
1. Motion control activator
2. Bit holder
3. Charger connector
4. LED work light
5. Charger
(Original instructions)
Before assembly, remove the bat-
tery from the tool.
Make certain the tool is locked to
prevent switch actuation before installing or
removing accessories.
holder (2) until it locates.
To remove a screwdriver bit, pull it straight
from the bit holder.
To remove the bit/socket repeat the
above steps.
Let the tool work at its own pace.
Do not overload.
power on jobs that were easily done before.
The battery may become warm while charg-
ing; this is normal and does not indicate a
problem.
To charge the battery, insert the charger
plug (5) into the charger connector (3).
Plug in the charger.
Leave the tool connected to the charger
for 16 hours.

Advertisement

loading