Initial Setup Of Au Media Tuner; Watching Tv (1Seg) - Hitachi WOO H001 Basic Manual

Initial Setup of au Media Tuner

To watch TV (1Seg) using the au Media Tuner, you need to
configure initial settings.
When the standby screen is displayed, hold down
f for at least one second.
Disclaimer notes are displayed.
Use j to check the disclaimer notes, use j
➡
to select OK, and then press c (選択 [Select]).
The initial setting screen for using the au Media Tuner is
displayed.
• Follow the on-screen instructions to configure each
setting. Then, the screen for setting TV (1Seg)
channels appears.
Use j to select オート設定（放送波） (Auto
➡
(Broadcasting wave)) and then press c (選択
[Select]).
Automatic channel scanning begins. When receivable
channels are found, the channel setup is completed.
• Select マニュアル設定 (Manual) to set the channel
manually.

Watching TV (1Seg)

When the standby screen is displayed, hold down
f for at least one second.
To Change Channels
■
Use s/LR to change channels.
You can select TV (1Seg) and EZ Channel-Plus/EZ Channel
programs.
TV (1Seg) TV (1Seg)
Change channels one by one. Change channels one by one.
1ch 1ch
EZ Channel-Plus/EZ Channel EZ Channel-Plus/EZ Channel
Program 16 Program 16 Program 2 Program 2
... ...
• Before using this feature, you must configure au Media
Tuner initial settings (see the procedure on the left).
• Channels cannot be changed with
operation screen is displayed.
2ch 2ch ... ... 12ch 12ch
Program 1 Program 1
when the data
47