Download  Print this page

Nady Audio GTH-100 Owner's Manual

Tube guitar head amp w/ reverb
Hide thumbs

Advertisement

O W N E R ' S M A N U A L
GTH-100
Tube Guitar Head Amp w/ Reverb

Advertisement

Table of Contents
loading

  Related Manuals for Nady Audio GTH-100

  Summary of Contents for Nady Audio GTH-100

  • Page 1 O W N E R ’ S M A N U A L GTH-100 Tube Guitar Head Amp w/ Reverb...
  • Page 2: Table Of Contents

    This unit was developed using the expertise of professional sound engineers and working musicians. You will find that your new NADY AUDIO GTH-100 has superior performance and greater flexibility than any other guitar amplifiers in its price range. Please read this manual carefully to get the most out of your new unit.
  • Page 3: Warning

    ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: Read all instructions before using the product. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.).
  • Page 4: Installation

    [Please note: Nady Systems is not responsible for shipping damage. If your unit is damaged, do not return to Nady, but notify your dealer and the shipping company (if shipped to you) immediately to make a claim. Such claims must be made by the consignee in a timely manner.]...
  • Page 5: Front Control And Connectors

    F R O N T C O N T R O L S A N D C O N N E C T I O N S (4) (5) 1. POWER SWITCH This switch turns the main power on and off. Flipping the toggle switch up to the ON+ position will turn on the amp “in phase”...
  • Page 6: Rear Control And Connectors

    Specifications (pg. 7) for the corresponding AC voltage being used. • Before you connect your GTH-100 to the AC, please make sure that your local voltage matches the Voltage Selector Switch. • Do not remove the center ground conductor.
  • Page 7: Specifications

    S P E C I F I C AT I O N S Power Amp Section ...Four EL34 Tubes Power Output ...100W RMS @ 4 — 8 — 16 5% THD Preamp Section ...Three 12AX7A Tubes Input Imp..HI input 200K , LO input 50K Input Sens.
  • Page 8 DO NOT ATTEMPT TO SERVICE THIS UNIT YOURSELF AS IT CAN BE DANGEROUS AND WILL ALSO VOID THE WARRANTY. NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608 Tel: 510.652.2411 • Fax: 510.652.5075 • nady.com...