the Clock and Timer
Use this pad to select broil. Two heat selections
available for broiling--Hi
and Lo. See page 10 for more
To set the time-of-day
1. Press the CLOCK
TIME" will flash in the display.
This pad is pressed to set the oven for a self-clean cycle.
2. Set tile correct time of day using the • and • pads.
See pages 12-13 for detailed information
on the self-
• To change the time by one minute, press either
• To change the time in increments
of 10 minutes,
These pads are used to program the oven to start and
press and hold either pad.
stop automatically; either immediately or at a later time.
When the power is first supplied to the range or if there
For detailed information
on using Programmed
has been a power failure, the display will flash. Follow
Operations, see pages I0-11.
to set the clock. The clock time
cannot be changed when the oven is set for a cook or
Cancel the operation
to set the
Press this pad to select convection baking and roasting,
Set the oven temperature
by pressing the • or • pad.
See pages 8 9 for more information
Press the CLOCK pad to recall the time of day when
another function is displayed.
To set the timer:
Tile oven temperature
is set by pressing this pad and
information can be found on pages 8 9.
TIMER" will flash in the display.
2. Set the desired time using the • and • pads.
The timer can be set from 1 minute to 9 hours, 50
• Press either pad once to change the time by 1
minutes. It will count down by seconds (when set for 1
(if the Timer is set for up to 1 hour), 5
minute) or minutes (when set for 2 minutes or more
minutes (if the Timer is set for over 1 hour), or 10
time). See next column for instructions on setting the
minutes (if the Timer is set for over 2 hours).
• Press and hold either pad to change the time in 5
minute or 10 minute increments,
the time set in the display.
Press or press and hold these pads to enter the time or
The TIMER can be set from 1 minute (0HR:01) up to 9
desired. These pads are also used to select
hours and 50 minutes (9 HR:50).
Hi or Lo broil.
The timing operation
will start automatically.
will flash in the display to indicate a timing operation.
One long continuous
bcep will signal tim end of the
timing operation and "End" will briefly appear in the
display. The time of day will automatically reappear in
the display. The TIMER
pad does not control
Press the TIMER
pad and hold for 3
seconds. The time of day will reappear
after a slight