Connection - Sanyo VA-EXD1B Instruction Manual

Hide thumbs Also See for VA-EXD1B:
Table of Contents

Advertisement

Available languages

Available languages

e05_l8hcc_us_7.fm Page 7 Friday, March 25, 2005 2:55 PM
1
INSTALLATION AND CONNECTION TO DVR
Attaching the external disc unit to the DVR
5
Place the DVR on the external disc unit.
(1) Insert the three legs of the DVR into the corresponding
holes in the top of the external disk unit.
The fitting should be positioned on the outside of the right
side of the DVR.
Hole
(2) Use the remaining screw (accessory) to secure the fitting
on to the right side of the DVR.
Tightening torque: 0.6 N•m - 0.7 N•m
6
Use the four screws removed in step 1,
to secure the DVR from the inside to the
external disc unit.
Tightening torque: 0.6 N•m - 0.7 N•m
Screw
If the HDD block was removed in step 4, reattach.
Tightening torque: 0.6 N•m - 0.7 N•m
7
Secure the cover on to the DVR using
the screws removed in step 4.
Tightening torque: 0.6 N•m - 0.7 N•m
English

Connection

Use the following procedures to connect the external disc unit
to the DVR.
1
Connect the USB cable and two power
cords.
Use the three power cord ties (accessory) to secure the power
cord to the power cord holder. (DVR: one tie, External disc
unit: two ties)
Fitting
Hole
USB cable
(supplied with external disc unit)
Attach the core clamp (accessory) to the USB cable
near the connection with the DVR.
Insert cable all the way so cables are not loose.
2
When you have finished making all the
other connections, make sure the
voltage is 120V - 240V AC and then
insert the power plug into the wall
outlet.
There is no power switch.
Screw
7
Power cord
(supplied with external disc unit)
Power cord
(supplied with DVR)
120 - 240 V AC
(50/60 Hz)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Va-exd1w

Table of Contents