Programming Console Operation - Omron CQM1H series Operation Manual

Programming Console Operation

5-2

Programming Console Operation

Initial Screen
1, 2, 3...
I/O Words
1, 2, 3...
Command
1, 2, 3...
Refer to the CQM1H Operation Manual (W363) or the CQM1 Operation Manual
(W226) for the detailed operating method of the Programming Console.
The operation of the Programming Console required for the initial settings is ex-
plained below.
Operate the Programming Console as described below so that the default
screen of the Programming Console in program mode will appear.
1. Connect the Programming Console to the CQM1H/CQM1 CPU, set the
mode selector of the Programming Console to PROGRAM MODE, and sup-
ply power to the Programming Console.
2. Input the password.
MONTR
CLR
3. The default screen will appear.
The contents of the I/O words will appear on the screen of the Programming
Console. When measured mode is selected for data input, the present binary-
coded scaled conversion data will appear under the input word display.
1. The input word (word 001 in this example) will be displayed.
A A
CH
0 0
SHIFT
*
2. The output word (word 100 in this example) will be displayed.
B A
CH
1
0
SHIFT
*
The command codes can be set to output word. In this example, descriptions are
given for the operation mode A.
1. The command code is set to the output word. The response for the com-
mand will appear under the input word display.
C
C
A
2
SHIFT 0
CHG
2. If any parameter is used, the contents of the output word will be replaced
with the parameter. The response to the parameter will appear under the
input word display.
C C D
2 2 3
CHG
<Program>
Password
<Program>
00000
CLR
c001
B
1
MONTR
0000
Output word Input word
c100 c001
A
0
MONTR
0000 0000
A A
0 0
WRITE
c100 c001
C000 C000
c100 c001
B
1
WRITE 2231 2231
Section 5-2
189