Air Filter Check; Air Filter And Cleaning; Assembly - Husqvarna TE 250-450 Workshop Manual

DRAFT
EINSTELLUNGEN UND REGULIERUNGEN

Air filter check

Turn rear pin (1) counterclockwise, remove it and release the saddle from
the front fastening screw.
"A" VERSION MOTORCYCLE: DISCONNECT THE BATTERY FROM
THE ELECTRIC SYSTEM as described on page a.10.
Turn forward the housing box complete with the battery (1) (it is not
necessary to remove the battery from its housing box). To gain access to the
air filter, lift a little the electronic power unit (2). Remove screw (3) and the
filter (4). Separate filter (5) from frame (6).

AIR FILTER AND CLEANING

Wash filter with gasoline and dry it fully. Plunge filter in special oil for filters,
then wring it to drain superfluous oil.
: Do not use gasoline or a low flash-point solvent to clean the element.
A fire or explosion could result.
: Clean the element in a well ventilated area, and do not allow sparks
or flames anywhere near the working area.

ASSEMBLY

To ensure tight fit, slightly (C) grease filter edge on side facing filter housing.
While re-inserting the filter into its housing, make surs that piece (A) is
turned upwards and edge (B) is on the left lower side of the filter case.
Reassemble the parts previously removed (battery: connect the positive
cable first).
: If the element assembly is not installed correctly, dirt and dust may
enter and the engine resulting in rapid wear of the piston rings and cylinder.
"A" VERSION MOTORCYCLE: CONNECT THE BATTERY TO THE
ELECTRIC SYSTEM.
Part. N. 8000 A2925 (03-2004)
REGISTRAZIONI E REGOLAZIONI
SETTINGS AND ADJUSTMENTS
RÉGLAGES ET CALAGES
AJUSTES Y REGULACIONES
BOZZA
D.31