Advertisement
F016 L70 452 - Vorderseite.book Seite 2 Dienstag, 14. November 2006 2:20 14
Product Specification
AMR 32 F
Part number (typ)
3 600 H88 ...
Rated power
400 W
Tine assembly width
32 cm
Grassbox capacity
31 l
Weight
9 kg
Protection class
Serial Number
See serial No 10 (rating
plate) on machine.
Intended Use
This product is intended for domestic, lawnraking,
scarifying and for the collection of leaves in the lawn
area.
Introduction
This manual gives instructions on the correct as-
sembly and safe use of your machine. It is important
that you read these instructions carefully.
When fully assembled the machine weighs approxi-
mately 9.0 kg. If necessary, obtain assistance to re-
move from packaging.
Take care when carrying the lawnraker to the lawn,
as the tines are sharp.
Delivered Items
Carefully remove the machine from its packaging
and check that you have all the following items:
– Lawnraker with handle assembly
– Handle bottom
– 2 bolts (fitted to handle bottom)
– 2 wing nuts (fitted to handle bottom)
– 2 pivot pins (fitted to handle bottom)
– 2 pivot covers (fitted to handle bottom)
– Grassbox
– Operating instructions
When parts are missing or damaged, please contact your
dealer.
13 • F016 L70 452 • 06.11
/ II
10 Serial Number
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use approved extension
cables. Contact your Bosch Service Center for de-
tails.
Extension cords/leads should only be used if they
comply with H05VV-F, H05RN-F types or IEC type
design (60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable when operat-
ing your product, only the following cable dimen-
sions should be used:
– 1.0 mm
– 1.5 mm
– 2.5 mm
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
English - 2
Operating Controls
1 Handle top
2 Switch lever
3 Securing knob
4 Mains plug**
5 Cable restraint
6 Handle bottom
7 Grassbox
8 Ventilation slots
9 Height of cut lever
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The tines continue to rotate for a few seconds
after the machine is switched off.
Caution - do not touch rotating tines
2
: max length 40 m
2
: max length 60 m
2
: max length 100 m
Advertisement
