Advertisement
II - Remote Control
1.Prepare the parts of the remote control.
2. Setting the code on the transmitter.
2-1. Remove the battery cover of the remote control.
2-2. Slide code switches to your choice for an ON and OFF position. Use a small screwdriver to slide each
of the switches.
2-3. Install a 9V DC battery ( included).
2-4. Install battery covers on transmitter.
3. Setting the code on the receiver:
3-1. Slide the code switches to the receiver. Be sure that the code is similar to the code set at the
transmitter.
4. For remote control wiring connection to the fan:
4-1. Follow the diagram below and be sure that exposed wires are secured inside wire nuts or the
terminal block.
Note: Wires from the house may vary in color and may not include ground wire (green).
4-2. When the wiring is completed, gently push wires into the junction box with wire nuts pointing upward.
From House
White
(AC-N)
Black
(AC-L)
Green
( for ground wire )
Secure with twist - lock wire nuts (Included).
III. Install the canopy
1.
Push up the Canopy until the two screws on mounting bracket
are engaged with Key Holes in canopy.
2.
Rotate the canopy slightly until the two screw heads are in the
small end of the Key Holes.
3.
Tighten both screws.
Transmitter
Code Switches
From Remote
White
Receiver
Code Switches
White
Canopy
P4
From Fan
White
( Motor - N )
Black
( Motor - L )
Blue
( for light kit )
Orange
( for up light kit )
Green
( from downrod )
Green
( from mounting bracket )
Key Holes
Screw
Advertisement
