Parent Unit Power Supply - Motorola MBP853CONNECT User Manual

2. Replace the battery cover over the compartment and gently tighten the
screw in a clockwise direction using a Small cross head or Flat end screw
drivers.
2.3

Parent Unit Power Supply

IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event of a
power failure.
1. Connect the small plug of the power adapter to the Parent Unit and the
other end to a suitable electrical outlet. Only use the enclosed power
adapter (5V DC / 1500mA) with micro USB plug.
2. Press and hold the
the Parent Unit.
3. Once the Baby and Parent Units are switched on, the display on the Parent
Unit will show the video captured by the Baby Unit.
4. If there is no connection or you are out of range, the video display will be
replace by a
Parent Unit closer to the Baby Unit until the link is re-established.
5. Press and hold the
finishes scrolling, to turn OFF the Parent Unit.
NOTE
The battery icon
parent unit will beep every 15 seconds. The battery needs to be recharged; it
will take 12 hours to charge fully.
12
P
POWER ON/OFF button for 2 seconds to turn ON
symbol and the unit will beep every 5 seconds. Move the
P
POWER ON/OFF button, until the progress bar
turns RED to indicate that the battery is low, and the
Getting Started