Performing Auto Calibration - Sony STR-DH770 Manual

SP A:
Speakers connected to the SPEAKERS FRONT A terminals.
SP B (*):
Speakers connected to the SPEAKERS SURROUND BACK/BI-AMP/FRONT HIGH/FRONT
B terminals.
SP A B (*):
Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND
BACK/BI-AMP/FRONT HIGH/FRONT B terminals (parallel connection).
(None):
[SPK OFF] appears on the display panel. No audio signals are output from any speaker
terminals.
* To select [SP B] or [SP A B], set the assignment for the SPEAKERS SURROUND BACK/BI-AMP/FRONT
HIGH/FRONT B terminals to [Front B Speakers] by using [Speaker Setting] - [Surround Back Speakers Assign].
Note
This setting is not available when headphones are connected.
[93] Adjusting Settings

Performing Auto Calibration

5. Performing Auto Calibration
You can perform automatic calibration from your listening position.
Select [Easy Setup] from the home menu.
1
Follow the instructions on the TV screen, then select [Start].
2
The measurement starts in a few seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
Select the item you want.
3
Retry: Performs the Auto Calibration again.
Save&Exit: Saves the measurement results and exits the setting process.
Exit: Exits the setting process without saving the measurement results.
For details on the measurement results, see "6. Checking Auto Calibration results."
Save the measurement results.
4
Select [Save&Exit] in step 3.
Note
If an error code or warning message appears on the screen in step 2, see "List of messages after
Auto Calibration measurements."
This setting is not available when headphones are connected.
Hint
The Auto Calibration function will be canceled if you perform the following during the measurement
process:
Press .
Press the input buttons on the remote control or turn the INPUT SELECTOR on the receiver.
Press HOME, AMP MENU or on the remote control.