Selecting The Front Speakers - Sony STR-DH770 Manual

Disconnect the headphones.
Remove any obstructions between the calibration microphone and the speakers.
For accurate measurement, make sure the environment is quiet and free from noise.
Note
The speakers emit very loud sound during the calibration and the volume cannot be adjusted. Be
considerate of your neighbors and any children who are present.
If the muting function has been activated before you perform Auto Calibration, the muting function
will shut off automatically.
It may not be possible to take the correct measurements or to perform Auto Calibration at all if
special speakers such as dipole speakers are used.
[91] Adjusting Settings Performing Auto Calibration
3. Connecting the calibration microphone
Calibration microphone (supplied)
Connect the supplied calibration microphone to the CALIBRATION MIC jack.
1
Set up the calibration microphone.
2
Place the calibration microphone at your listening position and set it at the same height as
your ears.
[92] Adjusting Settings Performing Auto Calibration

4. Selecting the front speakers

You can select the front speakers you want to operate.
Be sure to use the buttons on the receiver to perform this operation.
Press SPEAKERS on the receiver repeatedly to select the front speaker system you
1
want to operate.
The indicators on the display panel shows which set of terminals are selected.