Makita 3606 Instruction Manual page 6

2
1
001985
Straight guide (optional accessory)
003676
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Screw the guide bars into the holes in the tool base.
1
003680
Install the straight guide on the guide bars and adjust
the distance between the bit and the straight guide. At
the desired distance, tighten the wing bolts to secure
the straight guide in place.
1
3
003681
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
1. Screwdriver
2. Guide bar
2
1. Straight guide
2
2. Guide bar
3. Wing bolt
Templet guide (optional accessory)
003687
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, loosen the screws on the tool
base, insert the templet guide and then tighten the screws.
1
3
003691
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
5
6
003695
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by using
the following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
6
1. Base plate
2 2. Templet guide
3. Screw
1. Bit
7
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside
diameter of the
templet guide
7. Templet guide