Using The Remote Control; Auxiliary Mode; Loading Batteries - Sharp AY-AP9LW Operation Manual

USING THE REMOTE CONTROL

LOADING BATTERIES

Use two size-AAA (R03) batteries.
1
Remove the battery cover at the back of
the remote control.
2
Insert batteries in the compartment,
making sure the ± and — polarities are
correctly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a thin stick.
NOTE:
• The battery life is approximately one year in normal use.
• When you replace the batteries, always change both
batteries, and make sure they are the same type.
• If the remote control does not operate properly after
replacing the batteries, press the RESET button us-
ing a thin stick.
• If you will not be using the unit for a long time, re-
move the batteries from the remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit's signal re-
ceiver window and press the desired button. The unit
generates a beep when it receives the signal.
• Make sure there is no curtain or other object be-
tween the remote control and the unit.
• The remote control can send signals from up to 7
metres away.
AY-AP9LW_VN.indb 4
CAUTION:
• Do not allow the signal receiver window to receive
strong direct sunlight, since it can adversely affect its
operation. If the signal receiver window is exposed to
direct sunlight, close a curtain to block the light.
• Using a fluorescent lamp with a quick starter in the same
room may interfere with transmission of the signal.
• The unit can be affected by signals transmitted from
the remote control of a television, VCR or other
equipment used in the same room.
• Do not leave the remote control in direct sunlight or
near a heater. Also, protect the unit and remote con-
trol from moisture and shock which can discolour or
damage them.
Battery cover

AUXILIARY MODE

Use this mode when the remote control is not
available.
TO TURN ON
Lift the open panel of the indoor unit and press the
AUX button.
• The red OPERATION lamp (
and the unit will start operating in the AUTO mode.
• The fan speed and temperature setting are set to
AUTO.
TO TURN OFF
Press the AUX button again.
• The red OPERATION lamp (
NOTE:
• If the AUX button is pressed during normal opera-
tion, the unit will turn off.
GB-4
) on the unit will light
) on the unit will turn off.
AUX
4/2/10 2:41:45 PM